INFINITY Reference 5CH High-Performace Amplifier - REF-7005A

Infinity's Reference 7005A 5-channel amplifier provides a full system solutions without breaking a sweat, and it'll look good doing it. It delivers 50-Watts RMS to each of the front and rear speakers, and a ground pounding 500-Watts RMS to the subwoofer channel — a much better balance of "speaker-to-sub" power than most of conventional 5-channel amplifiers on the market. For higher output, you can bridge the amp to 3-channel mode and power your front speakers with 140-Watts per channel, while still delivering 500-Watts to the subwoofer channel. Speaker-level inputs allow the Reference 7005A to work in almost any system, even if you're keeping your factory radio. Separate high-pass and low-pass crossovers on the front and rear channels and dedicated low-pass crossover, bass boost, and phase switch for the subwoofer channel provides an incredible amount of control and tuning capability. The Reference 7005A is truly a total system solution in one easy to install chassis.

GENERAL SPECIFICATIONS

• 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
• 65 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
• 140 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
• variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
• low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
• bass boost on subwoofer channel (0-12dB at 45Hz)
• phase switch on subwoofer channel (0, 180 degrees)
• preamp and speaker-level inputs
• fuse rating30A x 3
• 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• WxHxD=360mm x 55.5mm x 180mm WxHxD=14-3/16” x 2-3/16" x7-1/8”

FEATURES

• Compact size- The Infinity Reference 7005A amplifier feature a low-profile chassis and a small overall footprint to fit in more vehicles where available space is limited.
• High and low level input- Speaker-level and low-level inputs allow the Reference 7005A to integrate with both aftermarket and factory car stereo systems
• Variable crossover and bass boost- Unlike many amplifiers available at similar prices, Infinity Reference amps feature variable electronic crossovers and bass boost circuit to allow for fine-tuning
• Low noise and distortion- Produces tight bass with low distortion at high SPL. Balanced Differential Inputs are used to ensure low noise.
• Input Level Control- When low-level inputs are used, this control adjusts the input sensitivity between 200mVrms and 2.0 Vrms. When high-level inputs are used, this control adjusts the input sensitivity between 2Vrms and 20Vrms.
• Full on-board protection- The on-board circuitry to protect them from shorts, temperature, over- voltage and under-voltage. An LED indicator is included on all four models to let you know when one of these conditions exists.
• Phase Switch- This switch changes the input phase to inverted or non-inverted. This is especially helpful with the subwoofer channel.
• RBC wired remote- The RBC wired remote is an easy installation and can be mounted for convenient volume adjustment from driver's seat.

WHAT'S IN THE BOX

• 1 x Reference 7005A five channel amplifier
• 4 x Bare wire-to-RCA adapters
• 6 x 30A ATO fuses (3 installed, 3 spare)
• 1 x Remote bass control module
• 1 x 16.5' Remote control cable (RJ-25 plugs on both ends)
• 2 x Self-tapping screws for remote (M3 x 15mm)
• 4 x Mounting screws (M4 x 53mm)